What Is a Saltwater Disposal Well?

 By Wendy Lyons Sunshine, with SME opinion by Dr. Sakharov in underlined bold
 

The process of oil and gas production creates "saltwater," which is considered hazardous waste because of its high salt content, hydrocarbons, and industrial compounds. Hydraulic fracturing of shale gas well sites produce millions of gallons of this saltwater, also known as "produced water" or "oilfield brine." The water brings oil and gas to the earth's surface where impurities are chemically removed [only partly removed, so far there was no economically viable technology to filter out everything, that's why after the basic filtration the rest is dumped to the disposal injection wells],  resulting in a leftover liquid that must then be safely discarded.  

Companies can recycle the water, injecting it back into working  reservoirs for reuse in gathering any remaining oil or gas, or they can  discard it at a saltwater well disposal site. Placement of these  high-pressure disposal sites can be a controversial issue because of the  potential for groundwater contamination and small earthquakes. [...and water spills, we know of al least one case in Oklahoma when a disposal well backed up resulting a contamination of the surface]

Saltwater Disposal Well Construction  

The Environmental Protection Agency (EPA) describes a saltwater disposal well as "a bored, drilled, or driven shaft whose depth is greater than the largest surface dimension; or a dug hole whose depth is greater than the largest surface dimension; or an improved sinkhole; or a subsurface fluid distribution system." Widely used since the 1930s, saltwater disposal wells contain the water so it can't contaminate land or water resources. Initially, the saltwater was largely disposed of in surface waters, but it has been captured in deeper wells since the 1950s. They're mighty fortresses designed to spare the environment the effects of gas and oil production, and each state imposes its own regulations on saltwater disposal wells as well. [Mighty fortresses, really? You can't even imagine how many wrecked wells are there. And nobody knows what is the status of shutdown wells that are just sealed on top.]

The EPA requires that wells intended to dispose of carbon dioxide or other hazardous wastes be constructed of as many as three layers. The first outer layer extends as deep into the ground as necessary to protect area groundwater. It's typically constructed of steel pipe and cement. Another layer covers the entire well, and a third encloses the injection device. This triple-layer system means that all three protective coverings must be breached before contamination of surrounding groundwater can occur. The EPA categorizes all saltwater disposal wells into six separate classes based on their construction and their operating features.  

How Saltwater Disposal Works

Saltwater is typically ejected from the wells into natural underground formations sealed within an impenetrable rock to prevent the saltwater from escaping into surrounding soil and groundwater. These formations are commonly deep beneath the surface soil layer and are comprised of limestone or sandstone. The Environmental Protection Agency keeps a close eye on this saltwater well disposal sites and it’s not an easy job. More than 50,000 well sites exist in Texas alone. [Please note that EPA monitors only operational wells, not discontinued. For example, Texas had 12,797 operational disposal wells as of 1Q2021. All the remaining 120,099 wells are discontinued and sealed, and nobody knows what is happening below the surface.]

Individual states and tribal governments can request “primacy” or the  right and responsibility to enforce regulations within their  jurisdictions if they meet federal UIC requirements. As of October 2015, 33 states and three territories have qualified for primacy. The EPA regulates saltwater disposal wells through its regional offices in 10  other states and for most tribes, as well as the District of Columbia  and two U.S. territories. It shares responsibility for enforcement with local agencies in seven states.  

The Safe Water Drinking Act, passed in 1974, requires that the EPA maintain minimal federal requirements for the practice of saltwater disposal and regularly report on them to Congress.